Search results for: '【Tg:EAtradingSignals】-Top 10 Best Crypto Telegram Bots In 2024 - Coincu'

CGZP Module 4 rack made of 10 x 10 mm nylon, 1m

FROG-PC Foundation box in steel with cataphoresis treatment, complete with unlocking lever, fixing bracket to the gate and screw for adjusting the limit switch point in opening

FROG-CFN Foundation box in steel with cataphoresis treatment, complete with unlocking lever, fixing bracket to the gate and screw for adjusting the limit switch point in opening

Antenna tuned at 433.92 MHz.

Antenna tuned at 868.35 MHz.

Control board for decoding and access-control management via keypad selectors. R800 plugs into recent control panels.

Make sure you choose the correct number of casements and manual releases so it matches the number of motors that you need.

Use this tool to build a FROG kit of your choice:

-Motor and Control Panel. The panels match the chosen motor.

-Manual release type. Choose from lever, trilobe or custom key.

-Remotes. Choose between 2 button and 4 button, fixed or rolling code.

-Foundation casing. 

-Photocells. 

-Choose whether you need a radio card and/or antenna.

Complete kit for a sliding gate weighing up to 400 kg / max width 10 m

CAME Connect	European Standards

VD908  Adjustable mini-loop exit sensor

New mini-loop kit with adjustable sensitivity module and new probe 

FA.T80   CoBRA programmable beam

Programmable range photobeam, one side only. Set range on DIP switches, or fully adjustable. 

Ethernet Gateway module with built-in radio, with the CAME CONNECT dedicated system (002RSE module included). For controlling up to five slave modules.

The VD907 vehicle loop detector allows "free passage" of vehicles passing overhead. These units are an installer favourite due to their small size and being self setting it's easy to install.

The VD906 vehicle loop detector allows "free passage" of vehicles passing overhead. These units are an installer favourite due to their small size and being self setting it's easy to install.

CGZ6 - Galvanized rack module 6 in 30 x 30 laminated steel, 1m

Pair of surface mounted synchronized, swiveling, infrared-beam photocells rated at 12 - 24 V AC - DC and battery transmitter. Range: 10 m.

The VD955 can be used as either a safety loop or free exit probe detector. It should not be used as a safety loop if used with a Free Exit Probe. 

The VD955 includes a VD.CI Interface board, to work with most gate automation control panels.

• 10-30V ac/dc
• Selectable for full loop or exit sensor
• Selectable fail safe (presence) or fail secure (exit)
• 10 sensitivities
• 4 frequencies
• Contact closure/opening time delay

Two-channel 433.92 MHz standalone receiver. Housing is IP54 (internal). 12 to 24 V ac/dc. Stores up to 50 remotes. Compatible with TOP, TAM, ATOMO D, TWIN and TTS coding.

LB180 is an interface circuit board to connect two batteries to a ZLJ24 control panel. The LB180 will keep the batteries charged while mains power is applied. It will switch over to the batteries when the mains power fails. 

LB180 takes two 12V batteries. The battery size depends on the anticipated use while running on battery, and the overall time the power is off. In UK, we can expect power outages to be about 10 minutes, but recent storms have seen several days outage.

Complete kit for a single swing gate weighing up to 500 kg / max width 3 m

CAME Connect	Encoder Motor	European Standards

Complete kit for a single swing gate weighing up to 300 kg / max width 4 m

CAME Connect	Encoder Motor	European Standards