Search results for: 'VEHICLE LOOP DETECTOR'

The VD907 vehicle loop detector allows "free passage" of vehicles passing overhead. These units are an installer favourite due to their small size and being self setting it's easy to install.

The VD906 vehicle loop detector allows "free passage" of vehicles passing overhead. These units are an installer favourite due to their small size and being self setting it's easy to install.

The VD955 can be used as either a safety loop or free exit probe detector. It should not be used as a safety loop if used with a Free Exit Probe. 

The VD955 includes a VD.CI Interface board, to work with most gate automation control panels.

• 10-30V ac/dc
• Selectable for full loop or exit sensor
• Selectable fail safe (presence) or fail secure (exit)
• 10 sensitivities
• 4 frequencies
• Contact closure/opening time delay

The VD961A, known as the Magna Sensor, is of a new generation of electronic sensors which do the job of a loop detector, except better and more reliably. The Magna sensor recognizes vehicles by the ferrous content of the car. Unlike ordinary loop detectors, the sensor adjusts for most drainage and access covers.

The VD963A, known as the Magna Sensor, is of a new generation of electronic sensors which do the job of a loop detector, except better and more reliably. The Magna sensor recognizes vehicles by the ferrous content of the car. Unlike ordinary loop detectors, the sensor adjusts for most drainage and access covers.

VD908  Adjustable mini-loop exit sensor

New mini-loop kit with adjustable sensitivity module and new probe 

100m drum of single core rubber loop cable for use with: VD907, VD906, VD955 detectors

A.Gtag   Unique ID vehicle tag 

The Gtag is a plug in USB device that transmits a unique ID to a receiver A.R22 in the access control system. Each receiver can save 340 Gtag's.

A.Gtag   Unique ID vehicle tag 

The Gtag is a plug in USB device that transmits a unique ID to a receiver A.R22 in the access control system. Each receiver can save 340 Gtag's.

A.R23   Vehicle ID receiver

The VD.CI is designed to accept a plug-in vehicle detector on one side and accept the appropriate wires through the terminal block on the other. This device is designed for detectors that have a solid state output but need a single relay output.

For use with: VD940, VD955, VD913

VY280t   Locking doo magnet with timer

FA.T80   CoBRA programmable beam

Programmable range photobeam, one side only. Set range on DIP switches, or fully adjustable. 

VY350w    Waterproof locking gate magnet

VY500f   Waterproof gate locking magnet

The VD959 'Dynamite' Adjustable vehicle loop detector is an absolute favorite for an EXIT sensor / Loop detector that requires no loops to be cut and is self setting, so takes a quarter of the time to install than the traditional loop detectors.

VD909   Mini-loop exit sensor

'Dynamite' vehicle sensors are the market leading detectors. No loops to cut. Self setting. The no brainer alternative to traditional exit loops.