Search results for: 'dure+e+e+e+photobeams+arm+each+to+diagnos'

DOC-E Surface fitting safety photocells 20m range ~ Replaced With The DLX30CEP

DLX30CEP - Direct Replacement

DLX30CEP is Came's latest traditional square surface photobeam. It replaced DELTA-E and DOC-E. 

Control card kit for operating during power outages and for recharging batteries, with battery housing

Barrier arm for G4000 cabinets, white 60x40mm. There are slots in each corner to take the red rubber strip part G0403. The G0461 reflective strips are recommended.

Barrier arm for G6000 cabinets, white 100mm diameter. This arm fits the G0605 arm clamp. The G0461 reflective strips are recommended.

Circuit board for self-diagnosing the electrical connections, 12 - 24 V AC – DC.

Make sure you choose the correct number of casements and manual releases so it matches the number of motors that you need.

Use this tool to build a FROG kit of your choice:

-Motor and Control Panel. The panels match the chosen motor.

-Manual release type. Choose from lever, trilobe or custom key.

-Remotes. Choose between 2 button and 4 button, fixed or rolling code.

-Foundation casing. 

-Photocells. 

-Choose whether you need a radio card and/or antenna.

Pair of surface mounted synchronized, swiveling, infrared-beam photocells rated at 12 - 24 V AC - DC and battery transmitter. Range: 10 m.

Complete kit for a sliding gate weighing up to 1500 kg / max width 20 m

CAME Connect	European Standards

Barrier arm for G4000 cabinets, white 60mm diameter. Fits the G0405 arm clamp. The G0461 reflective strips are recommended.

Complete kit for a sliding gate weighing up to 2000 kg / max width 20 m

CAME Connect	European Standards

Complete kit for a sliding gate weighing up to 2500 kg / max width 20 m

CAME Connect	European Standards

Semi-oval section barrier arm in white aluminum alloy.  A yellow rubber bump strip is fitted in a groove under the arm. Arm length is 4m for 3.75m opening.

G4000 are issued with the arm clamp for a rectangular arm. This G0405 is required for fitting a 60mm diameter tubular arm.

Drive arm for sectional doors with the distance between the upper edge of the door and the shaft-spring assembly between 300 and 600 mm

G6000 are issued with the arm clamp for a rectangular arm. This G0605 is required for fitting a 100mm diameter tubular arm.

White painted tube-section aluminum boom, with groove covering profile. Ø 100 mm, boom length: 2-6 m.

Straight drive arm and track with mechanical opening limit-switch.

Adapter arm for partially protruding overhead garage doors