Search results for: 'fail filling'

The VD907 vehicle loop detector allows "free passage" of vehicles passing overhead. These units are an installer favourite due to their small size and being self setting it's easy to install.

The VD906 vehicle loop detector allows "free passage" of vehicles passing overhead. These units are an installer favourite due to their small size and being self setting it's easy to install.

The VD955 can be used as either a safety loop or free exit probe detector. It should not be used as a safety loop if used with a Free Exit Probe. 

The VD955 includes a VD.CI Interface board, to work with most gate automation control panels.

• 10-30V ac/dc
• Selectable for full loop or exit sensor
• Selectable fail safe (presence) or fail secure (exit)
• 10 sensitivities
• 4 frequencies
• Contact closure/opening time delay

VD908  Adjustable mini-loop exit sensor

New mini-loop kit with adjustable sensitivity module and new probe 

LB180 is an interface circuit board to connect two batteries to a ZLJ24 control panel. The LB180 will keep the batteries charged while mains power is applied. It will switch over to the batteries when the mains power fails. 

LB180 takes two 12V batteries. The battery size depends on the anticipated use while running on battery, and the overall time the power is off. In UK, we can expect power outages to be about 10 minutes, but recent storms have seen several days outage.

LB90 is an interface circuit board to connect two batteries to a ZL90 and ZL92 control panels. The LB90 will keep the batteries charged while mains power is applied. It will switch over to the batteries when the mains power fails. 

LB90 takes two 12V batteries. The battery size depends on the anticipated use while running on battery, and the overall time the power is off. In UK, we can expect power outages to be about 10 minutes, but recent storms have seen several days outage.

Click here to view LB90 manual

Click here to view LB180 manual

FA.T80   CoBRA programmable beam

Programmable range photobeam, one side only. Set range on DIP switches, or fully adjustable. 

The VD959 'Dynamite' Adjustable vehicle loop detector is an absolute favorite for an EXIT sensor / Loop detector that requires no loops to be cut and is self setting, so takes a quarter of the time to install than the traditional loop detectors.

VD909   Mini-loop exit sensor

'Dynamite' vehicle sensors are the market leading detectors. No loops to cut. Self setting. The no brainer alternative to traditional exit loops.