Search results for: 'tg:tsuki717 enabl telegram plug alerts dexguru'

868.35 MHz plug-in radio frequency card.

433,92 MHz plug-in radio frequency card.

Control board for decoding and access-control management via keypad selectors. R800 plugs into recent control panels.

Complete kit for a single swing gate weighing up to 500 kg / max width 3 m

CAME Connect	Encoder Motor	European Standards

Complete kit for a single swing gate weighing up to 300 kg / max width 4 m

CAME Connect	Encoder Motor	European Standards

Complete kit for a pair of swing gates weighing up to 500 kg per leaf / max width 3 m

CAME Connect	Encoder Motor	European Standards

Complete kit for a pair of swing gates weighing up to 300 kg per leaf / max width 4 m

CAME Connect	Encoder Motor	European Standards

Complete kit for a pair of swing gates weighing up to 300 kg per leaf / max width 7 m

CAME Connect	Encoder Motor	European Standards

ZL60 Control panel for one or two leaf swing gates with dip switch settings, built-in radio remote programming and self-diagnosis of the safety devices.

CAME Connect	European Standards	Encoder Motor

ZL65 Control panel for one or two-leaf swing gates, with programming display, self-diagnosing safety devices and on-board radio decoding.

CAME Connect	European Standards	Encoder Motor

LB180 is an interface circuit board to connect two batteries to a ZLJ24 control panel. The LB180 will keep the batteries charged while mains power is applied. It will switch over to the batteries when the mains power fails. 

LB180 takes two 12V batteries. The battery size depends on the anticipated use while running on battery, and the overall time the power is off. In UK, we can expect power outages to be about 10 minutes, but recent storms have seen several days outage.

The VD.CI is designed to accept a plug-in vehicle detector on one side and accept the appropriate wires through the terminal block on the other. This device is designed for detectors that have a solid state output but need a single relay output.

For use with: VD940, VD955, VD913

R700 plugs into recent PCB's to interface card reader selectors to the control panel.

A.Gtag   Unique ID vehicle tag 

The Gtag is a plug in USB device that transmits a unique ID to a receiver A.R22 in the access control system. Each receiver can save 340 Gtag's.

A.Gtag   Unique ID vehicle tag 

The Gtag is a plug in USB device that transmits a unique ID to a receiver A.R22 in the access control system. Each receiver can save 340 Gtag's.

Make sure you choose the correct number of casements and manual releases so it matches the number of motors that you need.

Use this tool to build a FROG kit of your choice:

-Motor and Control Panel. The panels match the chosen motor.

-Manual release type. Choose from lever, trilobe or custom key.

-Remotes. Choose between 2 button and 4 button, fixed or rolling code.

-Foundation casing. 

-Photocells. 

-Choose whether you need a radio card and/or antenna.

The VD907 vehicle loop detector allows "free passage" of vehicles passing overhead. These units are an installer favourite due to their small size and being self setting it's easy to install.

The VD906 vehicle loop detector allows "free passage" of vehicles passing overhead. These units are an installer favourite due to their small size and being self setting it's easy to install.

A.K15   Realtime keypad

A.R23   Vehicle ID receiver