Search results for: 'tg:kaia770 devic motor's enabl address'

Barrier arm for G6000 cabinets, white 100mm diameter. This arm fits the G0605 arm clamp. The G0461 reflective strips are recommended.

Locking magnet brackets allow two flush surfaces in shear to be locked together by ofsetting the magnet or the armature plate. The brackets are aluminium. The Z bracket is 2 part with ant-slip teeth that is bolted together. The L bracket is a single piece.

Two way sprung loaded keyswitch. High security euro-cylinder. 

Used for hold to run applications such as roller shutter opening and closing. Hold to run is also required for automation where safety is critical, and the operator is required to to have visual contact with the risk zone.

Locking magnet brackets allow two flush surfaces in shear to be locked together by ofsetting the magnet or the armature plate. The brackets are aluminium. The Z bracket is 2 part with ant-slip teeth that is bolted together. The L bracket is a single piece.

Locking magnet brackets allow two flush surfaces in shear to be locked together by ofsetting the magnet or the armature plate. The brackets are aluminium. The Z bracket is 2 part with ant-slip teeth that is bolted together. The L bracket is a single piece.

119RIA047 is the manual release handle used on Came underground gate systems that have the A4364 fitted. This is the low security release mechanism. The release handle can be inserted at the base of the gate from either side of the gate. When inserted, turn the handle by about 120 degrees. When unlocked, the gate is disengaged from the underground drive.

RIY077 is a tri-lobe manual release key. It is used to open most Came sliding gate motor manual release covers. Once inside the sliding gate release compartment, there is a yellow knob to turn.  It also fits the manual release mechanism on Came FROG underground motor systems fitted with the A4365 release. These keys are sold singly, or in a box of ten. 

Automatic barrier kit using the legacy barrier cabinet on openings up to 5m. The cabinet includes a 24Vdc gearmotor with encoder.  The cabinet is galvanised steel in a grey finish. The set comes with a tubular arm with tip support post and reflective strips. Specify left or right hand.

RIA013 - Gearmotor Box

RIA014 - Lower Flange

RIA015 - Slow Shaft

RIA016 - End Screw

RIA046 - Transmission Lever

RIA083 - Encoder Magnet

RIA036 - Transmission Chain

RIA100 - Protective Cover

Heater kit with thermostat.

RIA042 - Release Hooking Lever

RIA043 - Gate Hooking Bracket

RIR306 - Transformer For ZL90 ZLJ14