Search results for: '【Tg:sally530】-Forex Trading Robots: Best Trading Bots For Automated Trading'

Inner reinforcement for semi-oval section barrier; indispensable for gross clearances exceeding 2.5 m.

Fastening flange for semi-oval section boom.

Control board for decoding and access-control management via keypad selectors. R800 plugs into recent control panels.

A4370 Drive lever for openings of up to 140° and gate leaves of max. 2 m in length.

LB180 is an interface circuit board to connect two batteries to a ZLJ24 control panel. The LB180 will keep the batteries charged while mains power is applied. It will switch over to the batteries when the mains power fails. 

LB180 takes two 12V batteries. The battery size depends on the anticipated use while running on battery, and the overall time the power is off. In UK, we can expect power outages to be about 10 minutes, but recent storms have seen several days outage.

Adapter arm for partially protruding overhead garage doors

Auxiliary contacts unit for detecting the boom position

RIR090 - Transformer For BX ZA3 ZA4 ZA5 ZC5 ZF1 ZM2

R700 plugs into recent PCB's to interface card reader selectors to the control panel.

The VD955 can be used as either a safety loop or free exit probe detector. It should not be used as a safety loop if used with a Free Exit Probe. 

The VD955 includes a VD.CI Interface board, to work with most gate automation control panels.

• 10-30V ac/dc
• Selectable for full loop or exit sensor
• Selectable fail safe (presence) or fail secure (exit)
• 10 sensitivities
• 4 frequencies
• Contact closure/opening time delay

FL180 Chain driven transmission lever for openings of up to 180° and gate leaves of max. 2 m in length.

Modbus TCP/RTU bridge for integration with third party systems.

Red/green LED strips for booms up to 4-m long

The VD.CI is designed to accept a plug-in vehicle detector on one side and accept the appropriate wires through the terminal block on the other. This device is designed for detectors that have a solid state output but need a single relay output.

For use with: VD940, VD955, VD913

Ethernet-WiFi Gateway for controlling, via the CAME Connect system, up to five 806SA-0040 modules over the radio-frequency connection.

Oval section barrier arm in white aluminum alloy. This version does not have the yellow bump strip. The arm has side grooves with a cover strip for the optional lighting pipe. Arm length is 4 m for a 3.75m opening.

Automatic barrier kit using the legacy barrier cabinet on openings up to 5m. The cabinet includes a 24Vdc gearmotor with encoder.  The cabinet is galvanised steel in a grey finish. The set comes with a tubular arm with tip support post and reflective strips. Specify left or right hand.