Search results for: 'disc photobeam oblong back housing ar easi to diagnos'

VY808i    Waterproof illuminated exit button

A.K15   Realtime keypad

DLX30CEP is Came's latest traditional square surface photobeam. It replaced DELTA-E and DOC-E. 

DLX30CIP is Came's latest traditional square flush photobeam. It replaced DELTA-I and DOC-I. 

VY280t   Locking doo magnet with timer

Hearing impaired and voice synthesis moduleElectronic module with techno-polymer body, equipped with a loudspeaker used for the playing back system voice messages. It has an audio-frequency induction system for hearing aids, in the "T" position. To finish off with the hearing impaired module. When combined with the corresponding front panel, it guarantees IP54 water and dust protection.

FA.T80   CoBRA programmable beam

Programmable range photobeam, one side only. Set range on DIP switches, or fully adjustable. 

FTL-P   Complete kit for a pair of swing gates weighing up to 200 kg per leaf / max width 2 m

Intensive Duty	CAME Connect	European Standards	Encoder Motor

The VD961A, known as the Magna Sensor, is of a new generation of electronic sensors which do the job of a loop detector, except better and more reliably. The Magna sensor recognizes vehicles by the ferrous content of the car. Unlike ordinary loop detectors, the sensor adjusts for most drainage and access covers.

The VD963A, known as the Magna Sensor, is of a new generation of electronic sensors which do the job of a loop detector, except better and more reliably. The Magna sensor recognizes vehicles by the ferrous content of the car. Unlike ordinary loop detectors, the sensor adjusts for most drainage and access covers.

Barrier arm for G6000 cabinets, white 100mm diameter. This arm fits the G0605 arm clamp. The G0461 reflective strips are recommended.

ZL65 Control panel for one or two-leaf swing gates, with programming display, self-diagnosing safety devices and on-board radio decoding.

CAME Connect	European Standards	Encoder Motor

VD908  Adjustable mini-loop exit sensor

New mini-loop kit with adjustable sensitivity module and new probe 

Make sure you choose the correct number of casements and manual releases so it matches the number of motors that you need.

Use this tool to build a FROG kit of your choice:

-Motor and Control Panel. The panels match the chosen motor.

-Manual release type. Choose from lever, trilobe or custom key.

-Remotes. Choose between 2 button and 4 button, fixed or rolling code.

-Foundation casing. 

-Photocells. 

-Choose whether you need a radio card and/or antenna.

Complete kit for a sliding gate weighing up to 1000 kg / max width 20 m

CAME Connect	European Standards

A.R23   Vehicle ID receiver

Complete kit for a sliding gate weighing up to 3500 kg / max width 17 m

Three-Phase	European Standards

Barrier arm for G4000 cabinets, white 60x40mm. There are slots in each corner to take the red rubber strip part G0403. The G0461 reflective strips are recommended.

Complete kit for a sliding gate weighing up to 400 kg / max width 14 m

CAME Connect	European Standards

Complete kit for a sliding gate weighing up to 600 kg / max width 18 m

CAME Connect	European Standards